Search results

I was replacing a cracked trim piece and noticed some rust forming underneath the weather strip. It’s been 2.5 years, and I’m in CA. :)

Had to help an older neighbor haul off their twin bed and frame. It is possible, but you gotta move your seat almost all the way up 😅

I finally found the source of the loudest rattle in the car. It’s coming from my passenger seat trim where the controls are. There appears to be some bracket with a hole in it and a stem that rests on it. Looks like there should be a screw or clip there. Can anyone confirm? You can just push...

Hand washed the car a few months ago and noticed it. Ignored it for a couple months since you can only see it from certain angles. But after washing it recently I can't unsee it. Was trying to save a trip to the dealer and go when my oil change is due but I'm at 40%. Sent Acura Customer service...

So a few of my doors are off and a passenger fender is raised slightly. When I press the door down with my hand it will sit flush. I went to one dealer in So Cal and service guy mentioned it's pretty common, his RDX was like that and then he took photos to forward it to a body shop but I...

I asked Eibach directly and here was their response: Fronts are 137-177 lbs/in , and rear springs are 86-255 lbs/in So, going off these specs the fronts are slightly stiffer than stock when full compressed and the rears are softer (assuming we have the same spring rates as the SI which is...

I've never seen this before. It looks like some type of glue or filler was painted over and the paint cured before the glue did making it crack. On the inside of the door of the rear driver side. Going to show it to the dealer when I get the maintenance but huh??

In my apartment's private lot. If I parked any farther from the line I'd be on the curb....no note or anything. I put a sign up next to it in case the neighbors saw anything to contact me. Anyone know of a good body shop in the Bay Area? Looks like the scuffs will buff out the panels easy but...

Drove it a couple days ago and it was fine. Started it up today and it makes a loud clunking/mechanical popping from the front end. Any known failures like this could be the source? Car handles fine and a spot check behind the wheel looked ok. Sound clip below

Drove past this DC2 and noticed we both were headed to the same place. Found it parked next to me when I got back to my car. =]

Anybody get a chance to do this yet?

Something I noticed quickly since CA has aggressive speed bumps every 10 ft in every parking lot. You can really feel the impact when it hits the rears. And I'm assuming it is because the stiffer rear end and thinner tires. But damn, It's comical at times, I wish the adaptive dampers mitigated...

I can't imagine it on mine. Anyone have a pic with a front plate attached or know of alternative mounts that don't require drilling?