treyk
Member
- Thread starter
- #1
I installed the front half of the eibach pro kit a few days ago and during the initial test drive there wasn't any sounds that immediately jumped out at me. But the next day when I went to drive I noticed a clunk from the drivers side but up by the steering wheel towards the top hat. So I jacked up the front again made sure everything was torqued back down to spec including the nuts at the top hat that require the hex key in the middle to tighten all the way.
The noise is still there and now I am wondering if it is possibly the strut bearing since it comes greased and on the driver's side I had a tougher time taking it off so now I think I may have accidentally wiped too much of the grease off of the bearing.
Anyone know what the issue could possibly be? I'm 99% sure everything is tight.
The noise is still there and now I am wondering if it is possibly the strut bearing since it comes greased and on the driver's side I had a tougher time taking it off so now I think I may have accidentally wiped too much of the grease off of the bearing.
Anyone know what the issue could possibly be? I'm 99% sure everything is tight.
Sponsored
