Search results

I ran ohm resistance on all of the parking sensors and on one side of a sensor isn't reading anything as all of the others run similar resistance on both sides of the sensor. I'm assuming that could be the issue. Does that sound right?

Excellent stuff. Running the multimeter on the control unit connector I'm using the power source (10) to the ground control units ground (15) 12.3v, Ground for from sensors (5) 10v, and Ground from rear sensors (16) .002v. Not sure why I'm getting such a variance but I assume somethings going on...

Yeah I’m not able to reset the PSR system via the dash since the function is in red. The data shows every sensor at 0 yrds even on a moving graph while moving objects closer to the sensors.

B2600-54. Not sure what that equates to.

Thanks for the help. I'm not able to select the parking sensor system as it's in red and isn't selectable. More troubleshooting I guess. Getting an odd code on the scanner.

Thanks so much! Found it, replaced it and still an issue. Dang.

I purchased this module to repair my wrecked 24 integra. Can't seem to find out where in the world it goes. Any ideas? part number 39670-3S5-A05

I have several times.

I have replaced a broken parking sensor and with the new sensor they're still not working. Is anyone aware of a PS reset for the integra? Seems easy on Acura's with the parking sensor on off button but in our vehicles that doesn't exist. Thanks for any help offered up.

Did you end up getting an answer on this?

Well now I’m getting all of these warning popping up. I have a nice scanner and it’s not pulling any distances on my parking sensors except front sensor temporary failure value 192 and same for rear. Any ideas?

I’m looking for the far left. I believe it’s green, brown, blue, gray but not sure what order they go in.

Do you happen to have the left side diagram just like this one?

I think they’re the wires for the fog lamp. Do you have a diagram for the lights? I really appreciate the help!

So I've got these figured out for the front impact sensor but can't seem to find where the other 3 go. Any ideas? @jayy_swish

Perfect! That helps identify 2 at least.

I believe one set is for the impact sensor but that leaves 3 that are a big question mark.

CVT. Yeah it's drives side. I took off all of the tape and insulation and the corresponding wires are nowhere to be seen.

Yeah it's an A spec

Does anyone have a wiring diagram for the engine bay harness? I have 5 severed wires in the Integra I'm rebuilding and can't seem to find their counterpart. Not looking for the engine harness but the (accessories?), like for the collision sensors.