Braum Falcon S

[TwinSkrullDesign]

So I'm trying to figure this out. Would I need to remove the seat position sensors from both seats so I can plug those in too, or do I only need to work with the airbag wires? I tapped in a 2 ohm resistor into the airbag wires on the driver side, before I did anything with the passenger side, and I still had the airbag light on. of course, now I know it needs a 2.2 ohm. Can you recommend a resistor for me? will only the Bride resistors work? I bought 2 of them for like $40. but they're just like 22 gauge stranded wire, so you have to strip the airbag wires to connect them. Is there something you can plug directly into the connector without stripping the wires and cutting the connector off?

The driver-side resistor needed is definitely a 2.2 ohm and 2.0 for the passenger side. Once I receive my Recaros, I was going to purchase some new plugs so I can create a closed loop resister plug to turn off the airbag lights.

I’m having my seats made to work with the OEM heated seats, so I’ll need to look into that as well. If you’re on Facebook, reach out to these guys who have swapped out the OEM seats with recaros.

Sponsored