slo_its
Senior Member
- Thread starter
- #1
I don't think I saw a thread on this yet, so I guess I'll start it. Also would be great if the moderators can create some sub sections like the CTR forums which will be handy as more people get their cars.
Just picked up today. Did a janky front license plate mount that is meant to be temporary till I figured out side mount.
- 4 x zip ties
- 2 x heat shrink electrical wire wrap
- electrical tape for all contacts against paint to avoid scratches
There's a hole in the middle with bracket behind it that fits the zip tie ends nicely. I used 4 to avoid twisting them, but I could probably also just use two and cover it all with shrink wrap which will look cleaner.
Electrical tape was the good quality stuff I use, which I think will be fine for a little bit. I would prefer something thicker. It's got enough friction to avoid shifting around on the paint, hopefully avoiding scratches.
Seeing the car in person, there's enough space to side mount without blocking parking sensors and vents, but it's going to be hard to figure out how to mount it, even for something custom.
Just picked up today. Did a janky front license plate mount that is meant to be temporary till I figured out side mount.
- 4 x zip ties
- 2 x heat shrink electrical wire wrap
- electrical tape for all contacts against paint to avoid scratches
There's a hole in the middle with bracket behind it that fits the zip tie ends nicely. I used 4 to avoid twisting them, but I could probably also just use two and cover it all with shrink wrap which will look cleaner.
Electrical tape was the good quality stuff I use, which I think will be fine for a little bit. I would prefer something thicker. It's got enough friction to avoid shifting around on the paint, hopefully avoiding scratches.
Seeing the car in person, there's enough space to side mount without blocking parking sensors and vents, but it's going to be hard to figure out how to mount it, even for something custom.
Sponsored