Anyone Order or Install Extreme Online Store Parts?

[treyk]

They also have a splitter:



I am personally not a fan of multi-piece splitters but some may like it and the prices seem amazing

Sponsored

 

[myhdnromance]

Nope, but thanks for finding them, now I have to buy the spoiler because my spouse saw it and likes it....

 

[Justpassedu]

Not so sure I like that front lip , may have to see it in person. From the pics its not looking so hot.

 

[Jayman84]

I installed there carbon wing just this weekend. It had a few quirks but went on just fine. They send the wing with pre-drilled holes in 8 spots that you can mount from the factory holes too. The screws were way too long though and didn't have any spacers so most of them I didn't tighten down fully due to risking damaging the wing. The 2 on each end did thread in all the way so the wing is very secure especially with the double sided tape they provide.

I'm looking a doing the front lip too but a little worried as they don't give install instructions and it looks like you would have to drill into the front bumper (even though the holes would likely be almost underneath where anyone would see). I would be more inclined to pull the trigger if I knew the holes were in the plastic undershield vs the bumper or if they used the stock holes that the undershield connects to the bumper with. Might try to get some more info out of them before I decide.

 

[treyk]

I installed there carbon wing just this weekend. It had a few quirks but went on just fine. They send the wing with pre-drilled holes in 8 spots that you can mount from the factory holes too. The screws were way too long though and didn't have any spacers so most of them I didn't tighten down fully due to risking damaging the wing. The 2 on each end did thread in all the way so the wing is very secure especially with the double sided tape they provide.

I'm looking a doing the front lip too but a little worried as they don't give install instructions and it looks like you would have to drill into the front bumper (even though the holes would likely be almost underneath where anyone would see). I would be more inclined to pull the trigger if I knew the holes were in the plastic undershield vs the bumper or if they used the stock holes that the undershield connects to the bumper with. Might try to get some more info out of them before I decide.

Looks great! Thanks for the extra details about the install.

 

[Ap2Iven]

I have EOS on my corvette (side skirts and front lip) I am very happy with fitment but they are so delicate. They have a few chips and chunks missing with every speed bump. So I’m constantly pulling out the plastic welder and filling in the cracks or missing parts lol. But they are cheap in price.

Sponsored