TopazM3
Member
Thanks for the good advice. I was planning to test fit without pulling the tapes. Good point about care for the OEM spoiler.When you get it, before you pull any adhesive or tighten any bolts, just lay it on the hatch and spend some time moving it around as much as possible, See how it lays the best. The bolts will basically define where it's going to sit. if it won't lay flat and flush on it's own, just know that tightening the bolts will not change this. Also, something I didn't do was completely tighten it down before removing the top of the adhesive strips, This will definitely show you how it's going to sit.
Also, take your time removing the stock spoiler, so you can put it back on if you need to. There's just a bit of adhesive on the ends, other than that just the clips hold it on the trunk, and most of them should be reusable if you're careful.
Sponsored