Parking w/ brake Control Module location?

[c34webb]

I purchased this module to repair my wrecked 24 integra. Can't seem to find out where in the world it goes. Any ideas? part number 39670-3S5-A05

Sponsored

 

[akoza]

Not sure whether this will be of any help, but on the RDX it's in the rear left C- (or D-?) pillar, according to the link below. May be a good place to start looking on the Integra.

https://acura.bernardiparts.com/Images/Install/2021_RDX_ParkingSensors_BII14291-26.pdf

The diagram on Dreamshop also shows the Integra one toward the left rear side, although it's not as specific as to where it's located. Good luck!

 

[jayy_swish]

Interior Trim Area File it will be listed as "AC" in the diagram

EDIT: realize the file doesn't look as easy to read as the online format lol, but if you scroll down you'll see it under the AC sub procedure. Ill attach a picture for your convenience

View attachment Interior Trim Area (Interior Moulding _ Trim).pdf

View attachment Parking and Back-Up Sensor System Component Location Index (Except Type-S) (Collision Avoidanc...pdf

 

[c34webb]

Interior Trim Area File it will be listed as "AC" in the diagram

EDIT: realize the file doesn't look as easy to read as the online format lol, but if you scroll down you'll see it under the AC sub procedure. Ill attach a picture for your convenience

View attachment Interior Trim Area (Interior Moulding _ Trim).pdf

View attachment Parking and Back-Up Sensor System Component Location Index (Except Type-S) (Collision Avoidanc...pdf

Thanks so much! Found it, replaced it and still an issue. Dang.

 

[jayy_swish]

Thanks so much! Found it, replaced it and still an issue. Dang.

What code are you getting from the module? Or is it a no communication issue

 

[c34webb]

What code are you getting from the module? Or is it a no communication issue

B2600-54. Not sure what that equates to.

 

[jayy_swish]

B2600-54 is parking sensor not initialized, try doing the rest on the parking module:

EDIT: just saw your other thread. Can you try erasing the code and seeing if it’s selectable? If not I would go into the data list in the module and see if all sensors are providing data

View attachment Resetting The Parking and Back-Up Sensor Control Unit (Collision Avoidance Module).pdf

 

[c34webb]

B2600-54 is parking sensor not initialized, try doing the rest on the parking module:

EDIT: just saw your other thread. Can you try erasing the code and seeing if it’s selectable? If not I would go into the data list in the module and see if all sensors are providing data

View attachment Resetting The Parking and Back-Up Sensor Control Unit (Collision Avoidance Module).pdf

Yeah I’m not able to reset the PSR system via the dash since the function is in red. The data shows every sensor at 0 yrds even on a moving graph while moving objects closer to the sensors.

 

[jayy_swish]

If there's no data being transmitted when you move something closer or further away then I would verify power and grounds at the module and then at the individual sensors.

As an added check I would verify the connection from the sensors to the module by Ohms checking the wires, just to rule out an open circuit, and check for a short also.

View attachment Parking and Back-Up Sensor Connector.pdf

View attachment Parking and Back-up Sensor System (KA USA DE4) (Collision Avoidance and Parking Assist Systems).pdf

Sponsored