I should not have used the term rattling, no sound, but vibrates at highway speeds. The passenger side was doing it at low speed, but I had not tightened the base to the motorized mirror portion well enough. Doing so fixed the passenger side. I also removed and tightened the driver side, but there was not room to tighten and it did not end up decreasing the highway speed mirror vibration on the driver side.
Yeah looks correct. It's just a passthrough with a power take off for that module that plugs in. I added instructions to my first post on changing the settings after you install it. By default the horn beeps or something when you lock the door.I’ve started working on the install and im trying to get a grasp on the wiring setup before taking anything apart. Theres not much documentation on the orange wire bundle on the “F” kit, does the setup I have in the photo look correct?
No. Remove the adhesive/foam/electrical tape from the cable and the whole thing should come off.
De-pin connector and remove the foam adhesive tape that sealed the bottom of the boot. Slide everything through. If you salvaged the tape reapply.I got the turn signals installed and now I’m trying to get the base swapped out. Did you cut this foam gasket from the mikstore base to get the wire out?
IMO, I wouldn't swap out the base until you tested the mirror before hand. I know it will save time and I was tempted to do it but you don't want to be in that situation when everything is swapped and something is broken.I got the turn signals installed and now I’m trying to get the base swapped out. Did you cut this foam gasket from the mikstore base to get the wire out?
Did anyone else have to "unlock" their plug? I have no idea what this means.
