Integra Type S Wheel Spacers

[typesrocco]

Hello everyone,

I'm looking to improve the stance on my Type S Integra. I came across these wheel spacers that seem to be pretty high quality.

https://oemplusmods.com/products/li...a-type-s-de5-2023?_pos=1&_sid=20f8316c8&_ss=r

I'm just not sure which size to get. Doesn't anyone have some recommendations? Thanks!

Sponsored

 

[Frenzal]

Why not post in the Type S section?

 

[Integra23]

There's already a discussion on this in the wheel and tire thread. Mine came in and I will be installing this weekend

 

[jchall30]

There's already a discussion on this in the wheel and tire thread. Mine came in and I will be installing this weekend

What size did ya go with? I have 15mm for the front and 20mm for the rear but haven’t installed them yet.

 

[Integra23]

What size did ya go with? I have 15mm for the front and 20mm for the rear but haven’t installed them yet.

That's what I also have. I think it will work with my 275 tire size. Need to see what kind of wood block I need to jack the rear up. I did get a low profile jack just for this car.

 

[jchall30]

That's what I also have. I think it will work with my 275 tire size. Need to see what kind of wood block I need to jack the rear up. I did get a low profile jack just for this car.

You can’t jack it up from the sides can you? Just the two middle point?

 

[Integra23]

You can’t jack it up from the sides can you? Just the two middle point?

Not supposed to on the pinch welds. They are for Jack stands. I could probably get a rubber block that would straddle it and put pressure on the frame.

 

[jchall30]

Not supposed to on the pinch welds. They are for Jack stands. I could probably get a rubber block that would straddle it and put pressure on the frame.

I thought I read you couldn’t. I’ll have to see if my jack will fit under the front. If not I’ll have to get a low profile one

 

[Integra23]

I thought I read you couldn’t. I’ll have to see if my jack will fit under the front. If not I’ll have to get a low profile one

That's where the service centers lift the car from.. so I'm sure we can do the same

 

[ender_ong]

I thought I read you couldn’t. I’ll have to see if my jack will fit under the front. If not I’ll have to get a low profile one

Would still be tough with a low pro floor jack. I got these to drive on before sliding the low pro jack under, works pretty well

Megan Low Pro Ramps

 

[typesrocco]

Why not post in the Type S section?

Didn't realize this was a different section. I'm new to the forum.

Sponsored