All About That Intake -- List of Air Intakes for Integra Type S

[LunaticSM]

Honestly I think it'll fit fine, there are a few guys that have installed the PRL inlet and HVI with the standard silicone coupler. In fact the box for my HVI doesnt even specify which coupler it came with, I just mentioned it in my previous post to be 100% safe lol.

I'll report back once I successfully or unsuccessfully get it installed

Sponsored

 

[Scrodee]

FYI, the Infinity Design intake can't be ordered on their main website (https://www.infinityautodesign.com/honda-civic-type-r-fl5) but I just saw that they now have a different website for the USA distributor where it sells for $1510 (https://infinitydesignusa.com/products/honda-civic-type-r-fl5).

Their intake looks great, on the other hand it seems like there's no built-in flexibility. I wonder if it allows for enough movement of the engine relative to the airbox. The stock setup has the corrugated rubber tube for that.

They have a carbon TIP as well. I personally love the matte carbon look. Was thinking about getting this combo.
I do think that, especially at these prices, the $0.02 worm gear clamps are cheap looking. They should provide something nicer than that… Anyone know of better clamps I could source myself?

Edit: Found these. They look nicer and apparently have better functionality. https://www.murraycorp.com/turbo-seal-constant-tension-clamps

 

[TXWayne]

Just ordered it! It was a good option for my previous car and folks had good experiences with it, so I'm going to give it shot.

Have you received this? I was looking at getting the PRL intake from Two Step but they inform me this morning that it is out of stock so I am looking at this, which is slightly cheaper. I had initially wanted to go with the K&N but the comments about build quality on here steered me away. I have the Acuity Stage 2 shift kit upgrade ready to go but will delay that until I get an intake since installing the shift kit requires removal of the stock intake anyway....

 

[StingertimeNC]

Unfortunately, I have not received it yet. They said that it was supposed to come back in stock late September, and I have heard nothing. Hopefully soon. I have not canceled the order or anything.

 

[Clark_Kent]

They have a carbon TIP as well. I personally love the matte carbon look. Was thinking about getting this combo.
I do think that, especially at these prices, the $0.02 worm gear clamps are cheap looking. They should provide something nicer than that… Anyone know of better clamps I could source myself?

Edit: Found these. They look nicer and apparently have better functionality. https://www.murraycorp.com/turbo-seal-constant-tension-clamps

Agree on the chintzy tension clamps. Black tension clamps would also look better. If you're having difficulty finding a good solution in black you could also spray paint them.

Sponsored